PRO-LINE PRO-MT 4X4 1/10 4WD MONSTER TRUCK ROLLER 1/10TH SCALE
Here is my eBay listing for it. If by chance you live in the Pierce Country Washington area you can get it for $250 "just DM me", eBay's fees are a tad bit high and that's why it's $305 on eBay.
PROLINE PRO-MT 4X4 1/10 4WD MONSTER TRUCK ROLLER
THIS IS LIKE NEW.
YOU WILL NEED TO GET YOUR OWN RADIO AND ELECTRONICS, THIS DOES NOT COME WITH ANY"
I have made a few changes to the truck, namely the upgrades that other PRO-MT 4X4 owners have recommended doing.
1. I added a custom homemade center chassis brace
2. Upgraded the plastic spur gear to the steel spur gear.
3. Upgraded the plastic shock caps to the aluminum shock caps.
4. Upgraded the steering servo saver with the aluminum upgrade part.
5. Upgraded the stock steering bell-crank single linkage with 2 small bearings to a custom homemade dual linkage withe 4 bigger bearings.
6. The stock 17mm wheel hex's have been replaced with RC8T3 FT 11.5 mm offset 17mm Wheel Hexes,
7. Installed clip rings on the front and rear diff impute cups.
8. I install a radio box and a raised platform to mount the ESC to.
The body dose have extra holes because I tried mounting it on a different RC.
Here is my eBay listing for it. If by chance you live in the Pierce Country Washington area you can get it for $250 "just DM me", eBay's fees are a tad bit high and that's why it's $305 on eBay.
PROLINE PRO-MT 4X4 1/10 4WD MONSTER TRUCK ROLLER
THIS IS LIKE NEW.
YOU WILL NEED TO GET YOUR OWN RADIO AND ELECTRONICS, THIS DOES NOT COME WITH ANY"
I have made a few changes to the truck, namely the upgrades that other PRO-MT 4X4 owners have recommended doing.
1. I added a custom homemade center chassis brace
2. Upgraded the plastic spur gear to the steel spur gear.
3. Upgraded the plastic shock caps to the aluminum shock caps.
4. Upgraded the steering servo saver with the aluminum upgrade part.
5. Upgraded the stock steering bell-crank single linkage with 2 small bearings to a custom homemade dual linkage withe 4 bigger bearings.
6. The stock 17mm wheel hex's have been replaced with RC8T3 FT 11.5 mm offset 17mm Wheel Hexes,
7. Installed clip rings on the front and rear diff impute cups.
8. I install a radio box and a raised platform to mount the ESC to.
The body dose have extra holes because I tried mounting it on a different RC.
Last edited: