pjoseph
RCTalk Qualifier
the manual for my nitro engine say it should be set between .3-.5mm but i have no idea how to confirm what i have it set at.
When i first start the engine i always have to open up the idle gap in order to get it started, usually to the point that the wheels start spinning right away. Once started i lower it back down, if i happen to run out of gas or stall out, it will not start unless i open up the gap again.
Could the above be a result of having the LSN set too rich? I would love to take the idle gap variable out of the equation by confirming what it is set out somehow.
Thanks
When i first start the engine i always have to open up the idle gap in order to get it started, usually to the point that the wheels start spinning right away. Once started i lower it back down, if i happen to run out of gas or stall out, it will not start unless i open up the gap again.
Could the above be a result of having the LSN set too rich? I would love to take the idle gap variable out of the equation by confirming what it is set out somehow.
Thanks