another stinkin problem

[unknown123]

i HATE MY STUPID SAVAGE!!!!!te stupid thing wont start!i was going to do my second tank for break in and now it wont start!!!
i checked the glow igniter and glow plug they work fine.I set the idle a little higher.But the stupid thing wont want to start!!!!!!!!!!!!!!!!!!!!!

 

[Eddie_m63]

Are you priming the engine correctly?

 

[unknown123]

i think i am.I cover the exhaust and using the roto start untill i see the fuel go in tht carb.Also it starts then dies out

 

[samrsnow]

preheat it to 200F and it will start. Blow through the presure line! Don't use the rotostart to prime a new engine! that is bad.

 

[unknown123]

ok =p

 

[Metalhead Matt]

Change the glow plug, too. Make sure the ignitor is fully charged. You can crack the glow plug loose, too. Just tighten it back up as soon as the engine starts.

 

[unknown123]

thanks guys i will try this and if it doesn't start i will take it to my LHS

preheat it to 200F and it will start. Blow through the presure line! Don't use the rotostart to prime a new engine! that is bad.

o i never knew you can't use the roto start:\

thanks =p

Also will this effect the break in if i use the roto start for priming?

Change the glow plug, too.

I'm wondering how do you charge a glow plug?lol=p



(I'm stupid=p)

 

[unknown123]

figured out the problem i had to lean it out about 1/8 a turn =p

 

[jasminemy4g63]

Another thing that will keep it from starting for future referance is a dead reciever pack or weak batts in the reciever pack found that out the hard way