3PK 2.4 FASST programing issue

[frickenjoey]

I picked-up a Futaba 3PK 2.4 a little while back. I have been crazy busy so I have not had a ton of time to use it really. Now the problem I am having is with my Savage and programing the third channel for the reverse module servo. When I power it up it currently puts the truck into a neutral position. So no go no....forward or reverse. I have read the manual and I guess I am totally missing the section that it is in because I am stumped. Any help would be apprciated. Thanks!

 

[Rolex]

I had a similar problem when I got the M11. If it's anything like that, you need to set the radio in 4 channel mode, then adjust the 3rd channel to work with a trim tab. Maximum % in either direction when you hit the trim. No more neutral, just full in or full out, instantly. You won't use the standard thumb button that would normally work the lap timer.
If you still can't figure it out, I'll try to find the info I got to make the M11 shift.

 

[frickenjoey]

That is not a bad idea but heck I can't even figure out how to get the thing to move out of the neutral position at all. It is rather frustrating. Does anyone out there use the third channel on their 3PK?

 

[Rolex]

Just to help you get started, go to the menu screen and find the ch 3 settings. It might just be listed as 'Aux'. If it's anything like the M11, you'll have to assign its' function as a single working servo, rather than a mix. At that point you can set it's properties.