3.3 Wont turn over with a glow plug in it

[savon]

Alright, my 3.3 wont turn over with a glow plug in it, i take the plug out and its fine and pulls no problem, i dont know what it might be.

Thanks in advance..

 

[chip812]

Glow plug too long? (causes too much compression)....???
Pull starter? Or ez-start??? ez-start battery too weak? or ez-start motor getting gummed up??? Need a little more info...

 

[savon]

The glowplug is the one that i have ran before, it's pull start..

 

[charliejp]

Is it stiff at either end of the stroke when the plug is out? How old is the motor?

 

[savon]

Is it stiff at either end of the stroke when the plug is out? How old is the motor?

No its not, the motor had about 15-20 tanks on it when got it, and i put about 5 since i got it so maybe a gallon, gallon and a half? When i take the plug out, there is alot of what looks to be nitro where the plug goes, it may just be flooded pretty bad, ill see if i can figure it out tomorrow then ill post here again.

 

[chip812]

Too much oil in the cylinder from the last after-run procedure????? (Oil won't compress)... Too much fuel won't compress either....

 

[savon]

I got it, it was flooded pretty badly its all good now though

 

[MotoGod]

I was gonna have to drive up there and beat you if you fried that motor already ;-) haha Yeah like I told ya originally when I sent it to you...if the pull starter gets hard to pull STOP PULLING IT. It's flooded ;-)

Glad to see it was just flooded....that motor has been bulletproof thus far. lol

 

[savon]

I was gonna have to drive up there and beat you if you fried that motor already ;-) haha Yeah like I told ya originally when I sent it to you...if the pull starter gets hard to pull STOP PULLING IT. It's flooded ;-)

Glad to see it was just flooded....that motor has been bulletproof thus far. lol

Haha, i stopped pulling when it wouldn't pull like you said, can't wait to get the revo back running.

 

[MotoGod]

Yeah the 3.3 floods easily if you over-prime it...at least from my experience. Just yank the plug, flip it over and pull the starter 4 or 5 times. Clears out pretty easily ;-)