2.5 3.3 revo chasis

[bones7933]

Is the chassis the same on the 2.5 and 3.3 revo? Can I swap all my parts over to the 3.3 chassis, what would I need to do this?

 

[ausher]

3.3 is 30mm longer. You'll need a longer front center shaft and steering turnbuckles.

 

[bones7933]

Would the front center shaft for a 3.3 work, just use it instead of the 2.5? What turnbuckles would I need

 

[ausher]

Yes center shaft from a 3.3 and 3.3 steering turnbuckles.

 

[bones7933]

That's all ill need to transfer over all of my stuff over to the 3.3 chassis? All shocks and everything else will switch over? The center shaft for a 3.3 and the steering turnbuckles? Sorry to be repetitive but I'm just trying to make sure, thanks for your time and help

 

[ausher]

Yep. That's it! Everything else is a direct swap. First thing I did when I got a 2.5 was go on eBay and order 3.3 chassis, center shafts and steering turnbuckles. Have fun and don't stop there. I sure didn't lol...

 

[bones7933]

I wont! It already has a picco .26 Max motor swap, I'm looking to do some mods for sure on it, it screams!

 

[2revo1maxx]

You're looking for the tie rods that go from the servo to the steering arm.

 

[bones7933]

Ok so I need the front center shaft for a 3.3, steering turnbuckles, and tie rod ends all for the 3.3 to do the swap?

 

[2revo1maxx]

Front center shaft and tie rods....just the tie rods that go from the servos to the steering arm only.

 

[bones7933]

Thank you for the help

 

[ausher]

Yea tie rods that's what I meant. Sorry for confusion.