General RC Information
Warby's Mugen MBX6 ECO build
I purchased this used Mugen Seiki MBX6 Eco 1/8 buggy roller from eBay. I was only going to do some maintenance and fit some electronics but ended up doing a full restoration, as I tend to do. Ongoing build.
Upgrades & Options:
Mugen parts
E0831 Mugen Titanium Screw Set A (upper)
E0177 Anodised Al. Front Upper Arm Mount
E0185 Anodised Al. Rear Lower Arm Mount
E0173 Anodised Al. Rear Uprights(bearing carriers)
B0429 Anodised Al. Servo Horn Set
MBX7 motor mount
MBX8 Servo saver adjuster nut E2320
MBX8 hex hubs
MBX8 Anodised Al. Wing Buttons
MBX8 Anodised Al. Closed Wheel nuts
MBX8 Eco body
T-Works parts
Titanium Turnbuckle set
Titanium droop screws M4x10mm
Titanium servo screws M3x12mm
Pillowball cups
Aluminum Wing Buttons grey
Hard coated Aluminum servo saver arm
Alum. Centre Drive Shaft Safety Collars
Others
RJX Hobby Kevlar, anti-slip battery straps
MBX7 DE Racing front bump/skid
T-Bone Racing rear skid
Plaig Bearings V2 Premium sealed bearings
Wheels/Tyres
Set 1 VP-PRO WE-011 White /
Set 2 HotRace white dish / HotRace Amazzonia Soft
Set 3. Proline black dish / Badlands M2 MX
Check out the ongoing build thread for more info.
Build Thread Thread 'Warby's Mugen MBX6 ECO buggy'
- RC Type
- Buggy
- RC Brand
- Mugen Seiki
- RC Model
- MBX6 Eco
- RC Scale
- 1/8 Scale
Technical Specifications
- Power Source
- Electric
- Battery Type
- LiPo
- Motor Type
- Brushless
- Drive System
- 4WD (Four-Wheel Drive)
Additional Information
- Budget
- Over $1000
- Challenges Faced
- Finding some parts due to being discontinued.
