wont go foward

[cfewbopmec]

stripped my 1/8 monster truck right down re greased the diffs up cleaned everything put new pull start on new clutches on and new exhust seals on put back together started on the block started first pull runs real nice revs hard put on the ground and it went in reverse never done that before so stopped and started first pull again and still reverse it goes hard out real hard to steer cause it going full on backwards ha ha driving me nuts kept diffs seperate when doing them so didnt get mucked up so front went back in front and rear went in rear looking at the motor from the front when pull it it spins anti clock wise can anyone help thanks

 

[Snook Man]

Sounds like you installed both diffs upside down. What truck is it?

 

[cfewbopmec]

they can only go one way its a huada hobby 1/8 monster truck

 

[frickenjoey]

Never hear of that brand before but I am with Snook on this, most RCs you can get the diff in upsidedown/backwards....the ring gear on the wrong side of the pinion gear and it will make it run the wrong direction. I have done it before.

 

[SchrodeMode]

Never hear of that brand before but I am with Snook on this, most RCs you can get the diff in upsidedown/backwards....the ring gear on the wrong side of the pinion gear and it will make it run the wrong direction. I have done it before.

The best is when you only put one in upside down, then you get to play tug-o-war with one truck.

 

[frickenjoey]

Yeah.... I did that on my Ofna CRT X2.....at the track. I had just serviced the diffs and wouldn't ya know it. The rear was in backwards and I did not even notice it when I fired it up on the starter box.... dropped it on the ground to do a warm up lap......I got some laughs. (grumble grumble)