• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Why?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
^^that would be a great video, a vaporized 1/16 slash!^^
Ill be sure to video tape everything just in case it happens!

....I don't have any street signs though.....not close to where I run/live.
 
^^Pretty much the same^^
[ame="http://www.youtube.com/watch?v=-0R-MrslSyI"]Dance Me Outside - Where do you live? HD - YouTube[/ame]

Do you guys know of any taller 1/16 slash tires, they can be slightly wider but not too much.
 
That's just a dumb idea. Have fun vaporizing your rig into a street sign.


Why would you tell someone that? Its his money/time, and car, if he wants to try and stuff one in there i would enjoy seeing it, it would be fast, but it his decision to do what he wants, and no one should tell him its dumb...... If he Vaporizes it then it his loss.......
 
one thing if you do put a mamba monster in it it will be a tight sqweeze it was meant for like 1/8 so u may have to ask how to get it in there but i dont really know if that will be a problem but i would check it out
 
Does anyone know if any reputable manufacturer make e-maxx/t-maxx upper a-arms without the hoops that the shocks sit in?.....?....did that make sence.
 
I dont think they make them. Well I'm assuming because where would the emaxx put there shock?
 
Have you had a look at the way the savage upper a-arms are, that's what I'm looking for, I have this set of 20mm big bore MCD shocks that need to be used somewhere, and the hoops in the upper a-arms of the maxx series prevent me from using them there.
 
It all alloy parts in a plastic box. I get mad when I run out of parts before a project gets done, so usually I don't start them until I'm confident I have everything.

The full FLM e-maxx kit showed up yesterday. Still gotta decide which bearing kit, and I still have to get some electronics. That high end Tx/Rx combo I wanted might become a reality sooner than I expected.
 
You may want to check with snookman I've seen a race tmaxx that had custom arms if I'm not mistaken
 
Ya snook man was the one who told me a lot of the UE parts aren't going to be available ever again, and to keep an eye and ear on ebay for what I'm after.

I might just get a hold of RC-Monster, or FLM directly to see if I can have something made.
 
Back
Top