What do you break the most?

[Mark_Sevier]

Hey guys.. trying to get a good list of some GOOD replacement parts to have around.. revo 3.3 and I was just curious... what do you break the most? If you had a bunch of extra parts in your tool kit.. what would they be?

Here is what I have so far.. Am I missing anything important?

A Arms
body clips
wheel nuts.
spur gears
Clutch bearings
Slipper pads
Wheel hex hub and pin
Carriers, pivot balls
extra transmission
after run oil
clutches
rockers
push rods

 

[stevecz28]

i like to keep extra shock parts on hand, along with a upper/lower a arm. never know when u will snap on of those

 

[olds97_lss]

I never broke/bent a pivot ball for the axle carrier when I had mine, but I did break the axle carriers. Since they are left/right specific, I upgraded to RPM carriers pretty early (along with RPM arms). I never had another carrier problem, but I did manage to break a couple of arms. Keep in mind, that was over about 2 years worth of bashing.

I agree with stevecz28 on the shocks. I broke few shock shaft ends off. Can't hurt to have a spare shaft or two laying around and a pack of the shock ends. The TiNi shafts seemed to hold up better for me.