• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

very weird electrical issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

GsElRiMkS

RCTalk Member
Messages
34
Reaction score
0
Points
0
Location
minnesota
RC Driving Style
  1. Bashing
Ok I just picked up a used revo 2.5 with a 3.3 on it, every thing else is stock, has the eazystart on it but needs a glow warmer, so here's the problem, when I put the glow warmer on it the trans shifts and the throttle servo moves a considerable amount, I was thinking a ground issue but none of the electronics touch the motor, any ideas? Please help thanks
 
It sounds like you have a bare spot on a wire...servo or antenna wire. I am also guessing you are running an AM radio. I had one that did that and could do nothing about it. Once I started it and let off the glow starter and roto start it would quit. Check all your wires...see what you find.
 
Thanks guys ill look around it for that and its not a twich it will fully shift in and out of reverse and fully closed to fully open throttle, and the lights on the opti drive flicker, but I have noticed teaching on my other cars didn't know that could be caused by the receiver being to close, thanks for the info
 
The metal on metal contact causes glitching in general. I used to have that before I got a 2.4G radio system. AM/FM both did it when I'd put the heater on the plug. AM was worse than FM and I didn't run AM for very long.
 
Back
Top