My Revo chassis keeps bending slightly right by the engine causing it to tilt foward and changing the gear mesh as well as contact between the spur and intake boot. Ya sure the picco .26 is probably the cause as it does weigh a little more but it runs way too good to consider going back! I was wondering if anybody has tried the vantage carbon fiber chassis and actully tested it in full race type enviroment, if so let me know becuase I'm thinkin SNAP :shrug:
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Vantage Carbon Fiber Chassis
- Thread starter Ragdoll
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
hi, i have the carbon fibre chassis aswell. but i havent used it yet. i have a tnt modded trx 2.5 waiting to go in it :idea: i have seen loads of pics of braces for both the stock chassis and the carbon fibre chassis. have alook at the pics
doing this takes alot of the flex away.
qoncepts make a chassis brace aswell but it hasnt been tested with a diff engine other then with they kit i think http://www.qoncepts.com/RCpages/TraxxasRevo.htm
Rb
doing this takes alot of the flex away.
qoncepts make a chassis brace aswell but it hasnt been tested with a diff engine other then with they kit i think http://www.qoncepts.com/RCpages/TraxxasRevo.htm
Rb
Last edited:
Revo Rancher
Hardcore RCTalk User
WOW! Nice mods!
