Too Sexy

[GrudgE]

Ok I have completed By Overhaul. I swapped everything from my 2.5 to a 3.3 chassis. I have RPM A-arms up front along with RPM axle carriers, RPM-TruTracks in the rear which come with Axle carriers. New Futaba 3pm 2.4 fasst radio with the newer battery Rx Box. New traxxas Waterproof servos all the way around. My 3.3 engine only has half a gallon thru it. I wrapped the Servo wires in Blue Wire loom (remnants of my pc building days). Rebuilt my shocks. New bearings on entire car. Have a Trinity Pipe coming from Ebay scored on Ebay. The most impressive piece is my new Pro-Line Protoform harddrive body painted by NcNitro. Here are the pics with all the different wheels and tires I got. By the Way the .com just wouldn't fit LOL.

 

[NCNitro]

Looks great Grudge! The body looks good on your truck, I am glad you liked it.

 

[MCNorris]

Lookin good buddy, now go get it dirty!

 

[flm_savage]

looking good!

 

[Rolex]

Slick, REAL slick. Just swap lids before you run it.

 

[revo_rob_1984]

its too clean u need to get a little mud on the tires. . .at any rate nice rig

 

[BOUTCH]

Now that is a real kicka** lid man!!!

 

[GrudgE]

Only reason its that clean is because, since I swapped it all over to a 3.3 chassis everything was apart so might as well clean all of it. LOL.

 

[jnjritz]

Sweet rigg... Hope you have a basher body

 

[Cupooterluvr]

It looks horrible. There's not enough dirt on it.

But really, it looks awesome, lol

 

[weezracen]

looks SWEET dude!!!!!!! I like the blue tube stuff ya used 4 the wires I might have to be a copy cat on that one haha!!!

 

[revo_rob_1984]

looks SWEET dude!!!!!!! I like the blue tube stuff ya used 4 the wires I might have to be a copy cat on that one haha!!!

true that. . .does the wrap come in red????. . .lol

 

[GrudgE]

you can get it in all kinds of colors have to remove the pins from the connector to get it to feed thru.

 

[revo_rob_1984]

How much of a pain is it to do that????. . .ehhh. . .i don't wanna steal ur idea. . .it look sweet though

 

[GH Racing]

awesome looking truck!

 

[h8z2luze]

Looks awesome man! Good job.

 

[GrudgE]

How much of a pain is it to do that????. . .ehhh. . .i don't wanna steal ur idea. . .it look sweet though

Its not very hard at all if you look at the connector, On the one side you can see the tabs on the connector that hold the pins in. I used a very small flat tip screw driver and ever so slightly lifted up on that tab while, gently pulling on the wire and pin slide right out. None of it should require any force. After the loom was on just slide the pins back in. remember what order they came out.

 

[NCNitro]

That does look really clean with the wiring like that, nice job!

 

[blckrevo33]

very nice, excellent job on the details. i relly like the wires.

 

[quadracer111]

"MOM, grudgE has a nicer revo than me!!"
"Ok, get in the car and we will go to the lhs, your spending limit is $500"
I wish!
Nice revo!