hulkmaxx
Wanna know my secrect. I'm always ANGRY!
- Messages
- 2,159
- Reaction score
- 96
- Points
- 685
- Location
- Grantsville West Virgina
- RC Driving Style
- Bashing
Does anyone know if the FOC for the #4907 trans will fit a #4909 maxx trans
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
tmaxx FOC question
- Thread starter hulkmaxx
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
chickenman242
Hardcore RCTalk User
Should do
You would have to change to 2 output shaft bearings to accommodate the 6 mm output shaft
You are aware that the output shaft is also longer on the 4907 foc
You would have to change to 2 output shaft bearings to accommodate the 6 mm output shaft
You are aware that the output shaft is also longer on the 4907 foc
Snook Man
Hardcore RCTalk User
Bearings are the same, just the length and shaft diameter are different.
hulkmaxx
Wanna know my secrect. I'm always ANGRY!
- Messages
- 2,159
- Reaction score
- 96
- Points
- 685
- Location
- Grantsville West Virgina
- RC Driving Style
- Bashing
- Thread starter
- #4
Yah I know the diameter are 6mm I did not know the length was different though. I am actually glad to hear the lengths are longer that will work out nice on my race maxx build. How longer are they, does anyone know.
Last edited: