Tmaxx 3.3 extended drive shaft

[mrbones]

Does anyone know where I can get an extended rear drive shaft? I'm doing a big block conversion and I can't find one anywhere. It's an extended frame with a 4907 trans. I'm having to move the trans forward a little and that makes the rear shaft too short.

 

[Nitro4910]

If you mean a longer plastic center slider use the out of the E maxx BL rear center.

TRA#5650 center tubes
OR cut down a wheel shaft to suite your needs
TRA#5450 wheel tubes

 

[Snook Man]

Another way to make up the distance of a short center shaft is to swap the stock diff input pinion with the revo center differential input or output pinion. They have a much longer pinion shaft and can be cut to length to take up a lot of distance.
You would need tools to drill a new through hole or cut flat spots to attach the drive yoke or dive cup however.
I use this method on a lot of custom builds when a certain length center shaft is needed and can not be found.

 

[mrbones]

Sounds good to me. Thank you