TMAXX 2.5 won't move!

[jb1974]

I've got a 2.5 Tmaxx and it won't move forward or in reverse. The gears don't show any damage. Every part on the truck is in the right spot and there is no damage any where. I was driving the truck around the yard and over some curbs when it just rolled to a stop. It will shift from forward to reverse. Any ideas would be greatly appreciaited. Thanks.

 

[Rolex]

What happens when you add throttle?
Is the CB turning? Is the spur gear turning?

 

[jb1974]

What happens when you add throttle?
Is the CB turning? Is the spur gear turning?

Spur gear is turning. Clutch bell is turning.

 

[brinburner]

it would be your slipper clutch tighten your spur gear, or get new pads and you should be able to destroy the curbs again

 

[Jacknifejuv]

I had that once , thought it would only be some thing little Turned out to be my conrod snapped. They dont like the snow do they .

 

[jb1974]

Wouldn't be the connector rod, the motor is running fine. I tightened the spur gear and that didn't help. I will be buying a slipper plate next. Wasn't running it in the snow, just around the yard.

 

[Rolex]

Now that you know the slipper is turning, the next check is the output shaft on the transmission.

 

[mtaylortank]

make sure you didnt lose any pins in your driveshafts i have had that happpen before. from not being tight enough. if it aint that and your out put shafts spinn the shafts then check your diffs. u mighta blown a bearing in the diffs. always check the simple stuff first cause sometimes it is just something dumb