throtle and brake problem

[MR.?]

i have a problem with my throtle and brake set up. the servo and the linkage is all stock

my problem is when i hit the gas i dont get full throtle so i adjust it so that i can but when i can it closes the carburator durasticly i didnt have this problem untill i got the lrp motor. please can some one help me?


Thanks,Jay

 

[jon2]

What radio are you using? You may have to adjust your EPA on the radio. If not than your linkage may not be long enough to accomodate the new mill.

 

[olds97_lss]

i can it closes the carburator durasticly

What do you mean by this? Do you mean that it's shutting the carb an killing the enigne? Or, do you mean it's putting a lot of strain on the linkage?

Also, you could take a look at this: https://www.rcnitrotalk.com/100/savage-linkage-mod/

I prefer these slides as opposed to the ones in the linkage mod: http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXBL82&P=7

I just don't like metal rubbing on metal. Especially on my throttle linkage.