• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Tell us your mods . You no you want to :)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Yes it will be used/raced when finished.
About 6 bills in it so far and 300+ hours of design and fabricating parts.
 
1-off custom chassis (5 piece) 3 ½ inches longer and ½ inch wider at the bulk head tabs than a stock short chassis.
New Era 4 point chassis braces
GA 7075 bulks with custom bulk braces
Custom rear chassis brace
Fully captured a-arm hinge pin system
HPI savage 25 diff housing and savage diffs with custom pinion shafts
Custom skids & wear plates
Custom shock towers and body post mounts
UE widetrack a-arms
Custom shocks (Ultra LX one shocks with revo VDP pistons, custom springs and compression limiters)
Custom shock to tower limiter
Revo wing mount with custom attachment bars
Tekno axle carries with custom 8mm stub axles with UE drive cups.
UE cups on the diff outputs and UE dog bones for wheel shafts.
UE cups and Bones for the center shafts
Custom single speed tranny with HPI 1/8th scale CD installed
Custom front and rear brakes with replacable shoes/pads
Ofna steering bellcrank system
Ofna 17mm wheel hexes
Custom Batt/receiver box.
Custom diff housing to chassis braces
Recessed Ofna fuel tank
When finished, it will be powered by an O.S.VG .30 and associated pipe.

And probably a lot I didn’t mention.

DSC04398.gif

That's one hot truck!
 
A-Arms - RPM (TrueTrack rear)
Air Filter - Motor Saver (HPI Savage)
Antenna Kit - Ofna 10140
Battery - Venom 1600
Brake - Revo Performance disc
Bulkheads - ACNCM
Bumpers - RPM
Chasis - FLM .21 Extended Chasis (old version)
Clutchbell - Axial AX0520 20T Vented
CVD's - FLM Front Drive Kit (FLM16055), 112mm dogbone
Differentials - E-Maxx
Drive Shafts - THS320
Engine - LRP Z.28R Spec III (ABmod)
Exhaust - Jammin JP-3
Fuel Tank - Ofna Violator 150cc
Receiver - Traxxas Link 2218 2.4GHz
Servos - HiTec HSR-5995TG (Steering) HS-5456MG (Throttle)
Shock Towers - UE Knucklehead
Shocks - Ofna LX One
Slipper - Traxxas 5352R
Slipper Pressure Plate - Traxxas 5351
Springs - Ofna
Spur Gear - Traxxas 3953 36-Tooth (1.0 pitch)
Throttle Linkage - Dynamite ProTune Kit
Tires - Proline Badlands
Transmitter - Traxxas Link 2238 2.4GHz
Wiring Harness - Traxas 3034
Wheels - Maximizer Beadlocks 1/2 Offset (1730)
 
Back
Top