• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Tekno throttle/brake servo mount ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
jon2

jon2

Nitro ASSpired!!!
Supporter
Messages
12,084
Reaction score
0
Points
0
Location
Oxnard
RC Driving Style
  1. Bashing
I got it and want to remove the bulky Throttle and Reverse box out in favor for the Tekno RC mount. Only issue I am seeing is that servo does not mount on with all four ears. I would accept even 2 one on each end but I can only get one end to sit down.

Anyone got this problem? I am sure I can hack it on there but if there is a standard method, I would rather go that route and keep it un modded.

Members?
 
I am using a Hitec and it fits fine as well.
 
Airtronics 94358.. Are the mounts specific to make?I saw nothing on the package.?.?
 
It's generic, but the Airtronics servos never seem to fit any mounting holes exactly. At least not any mounting holes on any of my rides.
 
Hmm I tried a Hitec 925 servo and it does notfit either
 
That's odd.
 
Very... I was hoping this would solve my non-running revo. Can y shoot a pic of yours? I am puzzled. Had I known this I woud have hacked my box up....LOL
 
I just went and looked.

I actually don't have the Hitec for the throttle servo. It's in the Savage. I have the Traxxas 2055 installed in the mount and it fits perfectly.
 
my hitec fits fine,
DSC01838.webp


DSC01839.webp
 
That is one sweet lookin rig you got there Beason(faty pipe). I was going to buy a tekno mout but i just hacked up the stocker worked fine for me. Its always something to back up on.

Bryson
 
I will have to take a shot of it when I get the camera back
It is just not even that close to match up to yours Beason.
 
I've got a JR 590m mounted on mine. the screws sit a little on the outside of each side. I may throw down a small washer on each screw to make sure its got its hold on the servo. However with a couple runs, its holdin good as is.

Mike
 
SnakEyez151 said:
I've got a JR 590m mounted on mine. the screws sit a little on the outside of each side. I may throw down a small washer on each screw to make sure its got its hold on the servo. However with a couple runs, its holdin good as is.

Mike
Click to expand...

I am going to run some countersuck washers taken from my GS Storm spares. It should hold up. I wil mount it tomorrow.
 

RC Builds

Back
Top