Techno Slash driveshaft question.

[BarnFabRC]

Anyone know what size grub screw goes in the rear cup to hold it on the slipper shaft?

Mine ejected on the last time out. I’m guessing it’s M4 x 4mm long but I want to confirm the length before I order a box of them.

 

[tntpoof]

so pulling opposite one off to measure it is a no?

 

[BarnFabRC]

so pulling opposite one off to measure it is a no?

No they’re completely different arrangements front and rear. Front uses a screw/pin.

 

[nino]

I'm guessing you're talking about the big bone center driveshaft. Don't you have any kind of m4 screw to check if that's the size?

 

[DavidB1126]

Techno is one of my fav genres of music. Tekno is prob one of my fav rc brands (even tho I don't got a Tekno, lol) Autocorrect. I hate it.

I have no idea what size screw it is.

 

[BarnFabRC]

Haha damn autocorrect. I was right. Same one they use in a MOD1 pinion M4x4mm. Turns out I had like 20 of em in the bottom of my pot PIT box