Beatnicboy
RC Newbie
So i am running my T-maxx when in three minutes the engine is overheated and it stalls, and wont start. I have no idea what to do. Please help!!!
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
T maxx overheating problems
- Thread starter Beatnicboy
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
bduce77
RCTalk Basher
old fuel?
maybe reset you needles.
or you may have something in the drive train that is tight
maybe reset you needles.
or you may have something in the drive train that is tight
Metalhead Matt
RCTalk VIP
I'd seal it and start just shy of factory needle settings. With fresh fuel, new fuel lines and a new glow plug.
Nitrobuzzard
Useless NOOB!!
- Messages
- 1,123
- Reaction score
- 28
- Points
- 703
- RC Driving Style
- Bashing
- Racing
Reset your needles to factory settings and start from there. Tune accordingly but keep an eye on your temps. If it shut off due to heat, then no, it wont start back until it cools down. The piston/sleeve is tapered and when it gets too hot, it expands resulting in a loss of compression. No compression=no running.
-Nitro
-Nitro