T maxx 3.3 problem HELP!!!

[Snook Man]

No need to remove or take anything apart to adjust the 5351x slipper clutch. Just tighten or loosen the nut. It also should NOT be tightened all the way down, that can/will warp the pressure plate that holds the shoes and cause problems sooner or later.

 

[hotrodrob]

+1 for snooks advise,i snug my slipper then back it off a 1/4 some guys 1/2

 

[will1234]

i have a trx2.5 engine but seems to only run when throttle is half open if i tinker with the high speed and low speed enough ill get it right enough to run half way good but when i back throttle down it dies i do have a seal bad on my gas tank is this the problem? it happend all of a sudden it wasn't when it was wide open ether it was like i woke up on day and this happend.

---------- Post added at 4:09 PM ---------- Previous post was at 4:04 PM ----------

i have a trx2.5 engine but seems to only run when throttle is half open if i tinker with the high speed and low speed enough ill get it right enough to run half way good but when i back throttle down it dies i do have a seal bad on my gas tank is this the problem? it happend all of a sudden it wasn't when it was wide open ether it was like i woke up on day and this happend.