Stuck please please help

[Bristar]

Hi ya Fella's

Ok, just going through my single sterring conversion, i've installed the servo no worries, i've connected the electrics no problems,

I've change my servo arm and uprated spring, easy...

Now comes my issue... It's the Proline servo steering arm, How do i connect the steering rod to the sterring arm.... Please help

I've included a couple of pictures and highlighted where i am talking about...

Much appreciated

Bristar

 

[akmadmaxx]

Put a screw in it?

 

[jetmechG550]

The arms is threaded, just put a little loctite on a screw and put it in, make sure it sticks out the backside about 2 threads but not much more so it doesn't rub the chassis.

 

[Bristar]

Yup got it now ty..

Just wasn't 100% sure... all done tested seems much quicker than the 2 stock servo's were....

We'll see though when i get out and test it out properly.. hopefuly tomorrow..

Weather dependant..bloody freezing here..

Cheers Bristar..

Oh what to do next.... FOC done! Single steering Servo Done! RPM arms on front Done! Any suggestions as to other good hop ups to consider getting done ??

 

[Monkey Wrench]

RPM arms on rear and RPM axle carriers.

 

[jetmechG550]

Motorsaver filter. Tubez. RD Racing Quick turn.

 

[Revo Rancher]

all done tested seems much quicker than the 2 stock servo's were....

We'll see though when i get out and test it out properly.

Yep, one of the best mods I ever did. Do the Slayden grind, too.

 

[SVORay]

RPM axle carriers and a 3pt roll bar

 

[truthseeker]

start taking off some weight. the traxxas hard-anodized pivot balls and hollow ball set are a good reduction of unsprung weight. the aluminum rocker posts will save some weight as well.

 

[Bristar]

OK so next up will be the RPM arms for the back of the car....

Just a quick question reference this single servo steering conversion i've done...

What have you guys done to plug the hole where the old stock servo was...
or have you just left a hole there ???

 

[jetmechG550]

Left the hole open, though I am thinking of taking a piece of lexan and mounting my transponder there.

 

[olds97_lss]

Put a screw in it?

I don't know why, but that comment made me laugh my azz off!

I'm still laughing :clap:

 

[Monkey Wrench]

I took a scrap piece of Lexan and used silicone to attach it to the chassis over the hole.

 

[dannyd]

I don't know why, but that comment made me laugh my azz off!

I'm still laughing :clap:

same here made me laugh too.

 

[jetmechG550]

I did have another comment but it would have moved this thread over to the FFA! LOL