bbayton88
RCTalk Basher
So I received my pull start from HPI and when I started to take the roto start off I stripped the Hex screwon the roto start base plate. The screw is flush with the back of the engine and I dont see how I can get that off. I got the other 3 screws off without a problem even though they all had loctite on them. When I went to remove the 2nd screw it stripped almost right away. BTW I was using the cheap HPI tool set that came with the truck. Is there anyway to get this off? I'm assuming I have to drill into the hex head and take it out that way but since its so close to the internal parts of engine I dont want to mess it up