• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Steering Servo Help!!!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
JsamcroD

JsamcroD

RC Newbie
Messages
14
Reaction score
0
Points
0
Location
Krugerville Tx
RC Driving Style
  1. Bashing
:surrender So after the new motor upgrade and new exhaust. I started having servo problems, got a crapy waterproof throttle and brake servo. The old futaba steering servo went out and now I'm putting a hitec metal gear servo on it. Id like any input I wanna make sure that i get this right the 1st time lol I installed the servo and am stuck trying to figure out the servo saver and who u figure out which hole to attach it to the holes are pretty small shoud I bore them out a lil bit? servo.webp
 
Last edited:
Also when I turned the remote and truck on and it centered moving right and left is no problem ( its not hooked up all the way yet as u can see) but when u turn it off the servo saver goes out further than it would when its turned that direction. As see in the pic
 
Guess nobody wanted to give me help lol :( I think I got the problem fixed well I hope we will see after wk
 
When starting for the day turn the TX on first, when done for the day turn the truck/RX off first.

For the servo saver, pick the hole that you want to use & drill it out to fit your hardware.
 
Last edited:

RC Builds

Back
Top