xxh0lywarsxx
RCTalk Basher
- Messages
- 79
- Reaction score
- 0
- Points
- 0
- RC Driving Style
I stripped my stock spur today.....i was wondering if there was any way to change the spur without taking off the throttle/brake servo mounts.....thanks
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
SPur Change
- Thread starter xxh0lywarsxx
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
All that should have to remove is the fuel tank. I believe you can just loosen up the mill & slide it over a tad. Personally, I would remove the mill & re-loctite the mounting screws after the spur change.
Domination
Hardcore RCTalk User
- Messages
- 1,328
- Reaction score
- 0
- Points
- 0
- RC Driving Style
when i replaced mine with a RRP i just took the mill right out the spur was wide open once it was out
He's useing XTM's 21 conversion which places the throttle servo in the way. It's a pita to do. I made a plate for the throttle servo with 2 bolts/nuts holding it on that i could get at without removing the chassis braces, fuel tank or engine.