Servo saver shaft screw keeps spinning not unscrewing

[street silence]

I screw the bottom screw but it unscrews it after I try to unscrew the top bolt. I’m trying to remove the top bolt for the servo saver but it looks like the threads are in the same Direction will a little 12v gun remove it?
I’m going to try the gun Once I ge it

 

[street silence]

Any ideas?

 

[cbaker65]

Any ideas?

If it is a metal post where two screws go in at each end an one end is screwed to the chassy ,
then it is quite possible that the post is spinning with the screw ,if that is the case ,then it requires
a pair of visegrip pliers an maybe a little heat on the screw head will help!..

 

[street silence]

If it is a metal post where two screws go in at each end an one end is screwed to the chassy ,
then it is quite possible that the post is spinning with the screw ,if that is the case ,then it requires
a pair of visegrip pliers an maybe a little heat on the screw head will help!..

I was able to cramp a bit of the shaft with my shock pliers and it worked out great