RPM True Track Rear A-Arms question?

[pjoseph]

I am in the process of installing the RPM true track a-arms, and noticed the connection point where the hub carrier connects to the bottom a-arm via the hinge pin is very tight. It does not move back and forth freely (see attached red arrows),
I wanted to ask if i should lightly sand the that part of the hub carrier in order to allow it to move more freely?

thanks

 

[JAMMER]

I am in the process of installing the RPM true track a-arms, and noticed the connection point where the hub carrier connects to the bottom a-arm via the hinge pin is very tight. It does not move back and forth freely (see attached red arrows),
I wanted to ask if i should lightly sand the that part of the hub carrier in order to allow it to move more freely?

thanks

You want it to move but first I would try moving it by hand back and forth first and try to loosen it up that way it probably does not need much. Ed

 

[olds97_lss]

It loosens up after a bit of use. I usually put bike chain wax on all my pivot points to help reduce binding.