Rotary Carb Problem!!

[jon2]

I have had it with this stupid carb on my mt12!!!:censored: :censored: I am sick of trying to find the way to get it to work!! It seems that on this particular carb, I can't find a way to set my throttle linkage to work right!! The damn thing opens up MID WAY and then stays there. I have to actually apply the brake in order for the carb to close!!!. How in the hell do I get this to work?. My other rotary engine ..12RSS was smaller and the position of the carb is closer. What the hell do I do?????:flaming: :flaming: :alarm: :alarm: :alarm:



BETTER YET!! Does anyone know of a slide carb that will fit onto this rig?

 

[Mugen-Racer]

I love my MT12. Never had a single problem with it and I've had it for nearly 2 years now. Definately my best engine I've ever had. What kind of car is it in? Sounds like it's binding up and not closing all the way. Either the carb is sticking or that the throttle linkage isn't set up correctly and that the linkage is binding and not pushing the carb closed. Can you snap a picture?

 

[jon2]

Not right now. I don't have a camera. It seems as if the link doesn't pull it closed and it doesn't push it open all the way!

 

[jon2]

Update!! I figured it out!! The linkage was too short.Unfortunately the LSN needle is out of spec I believe. Does anyone know the factory setting on this? For all of the needles?:hammer:

 

[Mugen-Racer]

Dayum, I'm out of town for 2 weeks. I have the manual and could tell ya. Sorry bro...

 

[jon2]

Let me know as soon as you can. I am getting spanked by brothers mt12 !!!

 

[jon2]

~bump~ I need help it doesn't seem to want to start due to the fact the settings are probably all off!! I need help on this!!!HELP!!!!!:alarm: :alarm: :alarm: :alarm: :alarm: :alarm: :alarm: :alarm: :alarm: :alarm: