roll cage for big block revo?

[FastLS1]

I'm looking to get a rollcage or make one, just wondering if there were any suggestions on how you made yours or where you got one. I would like to still use the stock body on this and dont want it to be to complex, just to protect the engine, it got a few scratches on her during break in, because i still need to make a roll cage. Please let me know, thanks

 

[olds97_lss]

I did a couple variations, but the first required the back of the body to be hacked and required a bit of creativity to mount the center of the body:

Then when I recently got my slayer, I had built a few more on different trucks, then took the same approach. Allows me to run the full body. The roll bar was one I tried to make for my jato, but the stock was too large to bend it enough to fit under the jato body, so, I threw it in a drawer and used 1/4" stock. I took a few kinks out of it and threw it on my slayer (which is quickly becoming a revo):

 

[FastLS1]

appreciate it