Revo motor pistition adjustment????

[Nitratex]

Hey guys and gals. I just bought a revo with a big block and can't figure out how to adjust the way it lines up with the spur gear. I know the paper trick but what screws do I loosen to move the motor.
Thanks
Bill Helms.

 

[REVO-5309]

Should be one under the motor in a forward/back direction. Unlike the mounting screws which will be up and down.

 

[Nitratex]

Thanks ill give it a look. Would I look under the exhaust end or the carb end of the motor.

 

[pitluver52]

Should be at the base of your mount. On the outside but could depend on the bb mount your using

 

[Macguyver]

some BB mounts have no adjustments

 

[ausher]

Do you know what kind of mount it is or a pic?

 

[Nitratex]

I bought it this way I think it's a traxxas bb kit here's some pics

 

[Nitratex]

I'm new at posting pics.

 

[Nitratex]

https://www.rcnitrotalk.com/forum/attachment.php?attachmentid=12218&stc=1&d=1359427345

 

[Nitratex]

I had to Jerry rig the throttle bc it wasn't hooked up when I got it and didn't want to pay 50 bucks for just a few pieces but this works just fine haven't had a problem out of it yet.

 

[ausher]

This is the Allen bolt to adjust the mesh. Loosen it and pivot it up or down. Also loosen the other one one, but it doesn't move up or down...

---------- Post added at 12:51 AM ---------- Previous post was at 12:49 AM ----------

I'm assuming there is no cover on the Roto start so it can clear the a arm because Traxxas BB mount is for bump start only.

 

[Nitratex]

Thank you ausher and yes you are correct. I was going to switch it to a pull start bc I only have one cordless drill battery. Luckily the boat I just got came with a roto start as well and the starter solving that problem.
Thank you for the info though.