Revo Faward only Conversion

[Richyfinn]

Hii all recently got a revo 2.5 upgraded to a picco.26 maxx the truck has had a faward only conversion, dies anyone know how i remove this to allow the car to reverse ?
Thanks

 

[CosmosGoat]

You will need to buy the parts in the trans that get removed with a FOC and also and extra servo and linkage. Just keep the FOC. It is much more durable anyway.

 

[jschleer]

I've got the same engine on my revo 2.5 and the tranny didn't hold up until I did FOC.

 

[Richyfinn]

will keep the FOC then. is the picco .26 the fastest engine for the revo ?

 

[hamz9561]

It's one of the best drop in engines available for the Revo IMO.

 

[jschleer]

It's the only BB that I've used ,but everyone recommended it and the THS pipe. I've got a top speed of about 55 mph and tons of torch with a 17cb, 34 spur gear combo. It will power into a wheelie at about 25mph! That engine is BAD!

 

[revo_rob_1984]

It's the only BB that I've used ,but everyone recommended it and the THS pipe. I've got a top speed of about 55 mph and tons of Torque with a 17cb, 34 spur gear combo. It will power into a wheelie at about 25mph! That engine is BAD!

I have the same engine in mine and every thing that he said is the same with mine except i don't have the THS pipe i have the TRX polished resonator single chamber and it will snap the front wheels up when it hits second gear as long as i have it tuned right for the day

 

[Richyfinn]

Yeah mine does wheelies but i dont think its going quite as fast as yours. Revo's are good i must admit. has anyone tried them supercharger kits ?

 

[Scrogg]

Worthless, you want it to go faster have it modded. Extreme RC Mods is a Picco guru, he'll make it scream even better.
A good clutch helps the Revo tons. With the stronger engines, you need to back off the slipper clutch as much as possible to save the tranny gears.