THEVULGARCOWBOY420
RCTalk Qualifier
rear exhaust gasket? I'm having trouble getting my manifold over the gasket and tips???
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
rear exhaust
- Thread starter THEVULGARCOWBOY420
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
THEVULGARCOWBOY420
RCTalk Qualifier
- Thread starter
- #3
I've tryed i all ready riped 1
What engine? What header? I've found that different engines/header combinations require different exhaust gaskets.
My aftershock came with one that is too large. No matter how hard you push, it wouldn't seat. I just replaced it with a spare GS gasket I had on hand. I think HPI ones for the savage are a little thinner as well, but I might be mistaken.
Kyosho makes a really thick one.
My aftershock came with one that is too large. No matter how hard you push, it wouldn't seat. I just replaced it with a spare GS gasket I had on hand. I think HPI ones for the savage are a little thinner as well, but I might be mistaken.
Kyosho makes a really thick one.
THEVULGARCOWBOY420
RCTalk Qualifier
- Thread starter
- #5
its an axial .28 and a tsais c5h rear set up.