MrSkeedleWeedle
RCTalk Member
- Messages
- 25
- Reaction score
- 1
Hi. On my ftx hooligan nitro I have gone through like 2 pull starters. My engine seems to like a decent bit of fuel to get it started nice and easy and this causes higher compression but not crazy hard to pull just slightly harder. The bit on the pull starter where to one way bearing goes into is just plastic and the one way bearing is a nut on the end and it goes into the pull start. When there is any high compression and I pull the starter is just slips as it's made out of plastic. Is there anything I can do to prevent the plastic getting all messed up such as putting something in the pull start to stop it slipping around so easily? Sorry about how long that question is its just so hard to explain. Sorry for that.