brianr2011
RCTalk Member
- Messages
- 33
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Bashing
- Racing
I wanna convert my 2.5 maxx to a pull start what parts do i need? i had read something about a backplate but I'm not sure. Any ideas?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
pull start 2.5?
- Thread starter brianr2011
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Skwerly
RCTalk Addict
- Messages
- 775
- Reaction score
- 2
- Points
- 165
- Location
- Ash Fork, Arizona
- RC Driving Style
- Bashing
- Crawling
- Boating
You just replace the EZ Start with the pull unit. It's straightforward. 
brianr2011
RCTalk Member
- Messages
- 33
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Bashing
- Racing
- Thread starter
- #3
no back plate or nothing like that?
Traxxasnewbie
RCTalk Member
- Messages
- 30
- Reaction score
- 0
- Points
- 31
- RC Driving Style
- Racing
also if u get a pull start do not pull it without it being on engine it will fly apart in your hand and make you say a few choice words.Trust me on this i found out first hand.when u peel the tape off it comes with keep it together.
brianr2011
RCTalk Member
- Messages
- 33
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Bashing
- Racing
- Thread starter
- #7
okay i was just making sure because the lhs said i needed a back plate which idk why i would but i thought id ask the pros an see. thanks guys