Ericehess
RCTalk Champion
- Messages
- 187
- Reaction score
- 77
Hey all. I'm upgrading my Vector SR48 with a bigger shaft and 35mm metal prop(plus 4000kv motor and 60A quickrun esc) and ran into an issue. The prop will hit the rudder on big turns. I can either cut the driveshaft and outside driveshaft sleeve a quarter inch or find a way to extend a bit and have prop past the rudder. Is it a bad idea to have the propellor past the rudder? Will this cause poor turning or excessive shaking and overall instability? I'd rather not cut part of the boat off if I dont have to. Thanks for any info.