problems with m.p sterring

[hb1111]

i did the m.p sterring hop up and now my turning radius seems worst then before i did it just like in the post,but mine hits the diff case so seems to limit it from going all the way did anyone else have this problem going to mess with it a bit later but figure i'd ask? thanks

 

[cvec7]

I've done the mod, never had any problems, but it probably helps that I have EPA's on my radio too...

 

[rossb]

Mine does not hit anything. Did you do it like this:

 

[Goose1072]

check the bar that connects to the steering rods I think you installed it wrong. Done it myself one time

 

[olds97_lss]

Rossb, where did you get the aluminum cross bar that goes from horn to horn?

 

[Goose1072]

you can get those at: RCMART
or get the whole set at:
http://www.rcxshop.com/product_info.php?cPath=23_25&products_id=385

 

[rossb]

Rossb, where did you get the aluminum cross bar that goes from horn to horn?

I got it at a LHS for about $8. Here is the actual part:

http://integy.automated-shops.com/c...p_catid=59&sid=4wSJJh0-c7nXCY5-51104428538.92

 

[olds97_lss]

Oh... it's integy. Nevermind.

Thanks.

 

[Goose1072]

I guess you dont like integy, The ones I posted are GPM.

 

[olds97_lss]

I"ve bought stuff for my maxx from integy and it's soft... too soft for this stuff.

 

[Goose1072]

go to rcxshop.com they have all the parts for the T-Maxx and the Savage

 

[hb1111]

mine hits the plastic on the diff housing when installed the dog bone slides right underneth it so when it hits its at max turning which is not to good,i have the bar facing the right way thanks

 

[Goose1072]

is the bar on top or at the bottom?

it should look like this when installed:
Savage mod

 

[rossb]

I"ve bought stuff for my maxx from integy and it's soft... too soft for this stuff.

The alloy bar I am using from them does not have this problem.


hb - Can you post a pic of what is happening?

 

[robmob]

The arms themselves are what is hitting the diff housing. Mine did the same thing. I ended up grinding a little off the edge of the arms that were hitting to give it more clearance and now it works fine.

 

[hb1111]

ok thats the same here in going to grind mine also thanks alot!!