Pro 1.5 Problems

[browners9]

JUST GOT 1.5 BACK TOGETHER
NEW PISTON N SLEEVE, ROD, GLOW PLUG BATTERY FULL CHARGE GETTING FUEL THROUGH CARB FELT LITTLE COME OUT THE CARB THHROAT WHEN TRY TO START WILL NOT FIRE OVER. OH YEAH EVERY NOWQ N THEN THE EASY START MOTOR WILL TURN OVER BUT NOT THE ENGINE. :surrender

 

[devinbrown07]

could it be the one way bearing, I'm not sure if t-maxx's have them...but if they do, that may be the problem....i dont know a lot about t-maxx'

 

[jay3]

Maybe ur O ring is bad? Or did I read wrong?

 

[browners9]

15 Pro

Maybe ur O ring is bad? Or did I read wrong?

GOT IT TO FIRE UP DIDNT RUN FOR ABOUT 5 SECONDS. O RING? THOUGHT ABOUT THE ONE WAY BEARING GOT MOTOR OF NOW CHECKING

 

[Rolex]

Please refrain from posting in caps. It's considered yelling on the internet and is hard to read.

 

[browners9]

sorry didnt mean to do that at my wits end with these things. how can u tell if the one way bearing is bad?

 

[Rolex]

If it spins freely when you try to start it. You can remove it, clean it and clean the shaft with denatured alcohol. If it works, you're in luck. They all oil up from time to time.
If it doesn't work, or quits pretty soon, it's worn out.
Be careful putting it back. Some of them will also fit backwards. Just make note of how it came out.

 

[browners9]

took out sprayed wd40 got good n clean put back in it started up its alive its alive. got through the first half tank of fuel run up to around 230 shut down to get fuel n let cool down b back at it in a little bit. should i be turning the trans and every thing while is running i dont have the clutch on.

 

[Rolex]

If it wants to chatter or creep, you need to lower the idle.