I got an rc10gt from a coworker with a still in box Picco .12r sg. I've found that the threaded portion is 1/4-28. I've measured the shaft where the clutch bell would go and it's .195 and the bell is .313. Where would I get bearing to fit that? How else could I mount the clutch bell? Is there a shaft with a 1/4-28 that I could use if I cut the shaft? The factory #7603 clutch nut is too small to thread on.
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Picco .12 clutch problem
- Thread starter Lee250
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
http://www.teamassociated.com/pdf/discontinued_items/tubGT_manual2.pdf
Maybe that will help been along time since I messed with one.
Maybe that will help been along time since I messed with one.
- Thread starter
- #3
Here is a pic. Nut on the left is the 1/4-28 the other 2 are the factory cut off nut and clutch nut
[/URL][/IMG]
<a href="http://s781.photobucket.com/user/toycamry1/media/20150531_155350_zpsrxmsbb1w.jpg.html" target="_blank"><img src="http://i781.photobucket.com/albums/yy100/toycamry1/20150531_155350_zpsrxmsbb1w.jpg" border="0" alt=" photo 20150531_155350_zpsrxmsbb1w.jpg"/></a>
now it works. the directions are when using their special cut off nut. The shaft on this engine is to big to use those nuts.
<a href="http://s781.photobucket.com/user/toycamry1/media/20150531_155350_zpsrxmsbb1w.jpg.html" target="_blank"><img src="http://i781.photobucket.com/albums/yy100/toycamry1/20150531_155350_zpsrxmsbb1w.jpg" border="0" alt=" photo 20150531_155350_zpsrxmsbb1w.jpg"/></a>
now it works. the directions are when using their special cut off nut. The shaft on this engine is to big to use those nuts.
