Battlesmurf
RCTalk Basher
http://viewmorepics.myspace.com/ind...viewPicture&friendID=42169338&albumId=2086438
Alright- got a ton of stuff for this one. It's a nice little car- I just don't use nitro so much anymore. Been a bit since it was run, but should run fine. Tons of extra parts here. I am willing to part this lot out from the ground up (I'd rather part out the car last). Willing to ship or local pick up. Located in Vacaville CA 95688. If someone came to me with $150 cash, I'd take it. Shipped/Paypal'ed will be a little more. If no interest is grabbed here, it goes to the 'bay like the penny baja
Pm here or email Battlesmurfdx AT yahoo.com
Thanks!
CAR
*Rs4 3 Evo. Lt. Weight Chassis, Carbon fiber upper deck, carbon front/back strut braces, motor saver air filter, yellow gears, light weight flywheel, foamies, THS tuned Pipe, aftermarket motor on hpi motor mounts (higher rpms). The only thing is needs is an on off switch. Stock HPI remote
PARTS
*Aluminum Rims/Wheels
*Stock Rims/Wheels
*Wheels+ PVC Rims
*stock chassis
* D Cell Glow Starter
* standard battery holder
* aftermarket battery (taped, might do well to re-seal or replace).
* motor saver + stock air filter elements
* duratrax silver plugs (new, 3 pack)
* aluminum knuckles, buckles, arms, etc
*dogbone bad (2 pc)
*steer gear box joints (bag)
*stock flywheel, pipe, lots of suspension arms, upper deck, front back strut towers, gears, screws, bearings, collets, etc etc
*2 lids
Alright- got a ton of stuff for this one. It's a nice little car- I just don't use nitro so much anymore. Been a bit since it was run, but should run fine. Tons of extra parts here. I am willing to part this lot out from the ground up (I'd rather part out the car last). Willing to ship or local pick up. Located in Vacaville CA 95688. If someone came to me with $150 cash, I'd take it. Shipped/Paypal'ed will be a little more. If no interest is grabbed here, it goes to the 'bay like the penny baja
Pm here or email Battlesmurfdx AT yahoo.comThanks!
CAR
*Rs4 3 Evo. Lt. Weight Chassis, Carbon fiber upper deck, carbon front/back strut braces, motor saver air filter, yellow gears, light weight flywheel, foamies, THS tuned Pipe, aftermarket motor on hpi motor mounts (higher rpms). The only thing is needs is an on off switch. Stock HPI remote
PARTS
*Aluminum Rims/Wheels
*Stock Rims/Wheels
*Wheels+ PVC Rims
*stock chassis
* D Cell Glow Starter
* standard battery holder
* aftermarket battery (taped, might do well to re-seal or replace).
* motor saver + stock air filter elements
* duratrax silver plugs (new, 3 pack)
* aluminum knuckles, buckles, arms, etc
*dogbone bad (2 pc)
*steer gear box joints (bag)
*stock flywheel, pipe, lots of suspension arms, upper deck, front back strut towers, gears, screws, bearings, collets, etc etc
*2 lids
Last edited:
