• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Sold / Found OS .15 CVR-X with T-Maxx Cut Shaft

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Status
Not open for further replies.

FastEddy

The Slowest Guy In Town
Supporter
RCTalk Vendor
Messages
14,677
Reaction score
16
Points
730
Location
El Dorado Hills, CA
This engine is used. It has around 2 gallons of fuel through it. When I removed it, t was running fine but has been in my parts box for a year or so. I used ARO when I put it away and whenever I remembered.

It still has good compression. I will not sell it as a running engine because I don't want to create any bad will if its not to the buyers liking. Someone may install it, and run it for a long time with excellent results, or it may not run at all.

If anything, the rotary carb and pull start are worth the money.

1- Used and a bit dirty OS .15 CVR-X
1- T-Max Flywheel setup minus clutch and bell.

25.00 OBO + shipping cost.
 
Status
Not open for further replies.
Back
Top