Nitro revo 3.3 pull start help!!!!!!!

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Traxxasgirl27

RC Newbie
Messages
3
Reaction score
0
Hi,
My husband has a revo 3.3 and when he got it 7 months ago it had a Ez start engine. He has since the switched it to a pull start and the engine is a lo c. I've done replaced the pull start,bearings,engine,air filter,tires,etc. Now the pull start cord is snagging and staying out then he has to loosen the glow plug to get it back in. When it doesn't get stuck the engine will crank for 2 seconds and cut off. He has done burnt a glow plug and replaced the old fuel with new fuel. Can anyone offer some suggestions?
 
Check the one way bearing isn't slipping on the shaft, also check for any snags or loose threads in the pull start cord.
 
Thanks we will look into this. At the moment he has pulled the entire truck apart and is driving me crazzzzzzzzzy. Thanks
 
Recoil,,,,,,, should always go back in,could be a stone in it too,bad spring
 

Similar threads

ccater1026
Replies
1
Views
535
Nitroman7888##
Nitroman7888##
ccater1026
Replies
15
Views
766
Nitroman7888##
Nitroman7888##
R
Replies
4
Views
2K
fernando mateus
fernando mateus
Back
Top