• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Nitro MT thoughts......

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

bustedgears

Hardcore RCTalk User
Messages
1,591
Reaction score
0
Points
0
Location
Baytown
RC Driving Style
Here she is:
O.S. Max .18 CVRX
Aluminum Arms
Aluminum Braces
Aluminum Shock towers
Aluminum C-Hubs
OFNA Air Filter
Hitec LYNX Sport Radio
F-350 Body
Black HPI Wheels
Proline Masher 2000 Tires


Nude Shot!Don't Get Too Happy.
1.gif


With Body
2.gif

3.gif


Is there anything I could be overlooking with this thing? It's been completely torn down and rebuilt. All it needs is the braking linkage. Reason why I'm asking is it seems to be a little on the weak side even with all the aluminum add ons.
 
Nice. How does it run
How is the Mill,

What is the GC on that thing w/ dogbones level.
 
That thing screams as far as I can tell. I ran it on the road for a quarter tank.

The mill has excellent compression. I think it only has maybe three or four tanks through it past break in. I still pulled it apart adn cleaned it out. The piston and sleeve aren't even tinned yet.

It sits right about an inch and a half level with my setup and these masher 2ks.
 
Lookin' good! I know it's a nude shot, but don't you think no air filter is a little to "steamy" for the younger viewers??? lol.

If you come up with a good throttle/brake linkage mod, I'd sure be interested to see it.
 
aluminum knuckles, aluminum C-hubs, aluminum rear hubs, aluminum hinge pin mounts, and aluminum threaded shocks. that stuff will increase durability and the shocks are a huge performance benefit over the stock stuff. I've done the dual disk mod on my old MT already and i think you would be better off with a metal brake disk and fiber pads on the metal calipers. i didnt like the dual disks so i took them off.

oh, and throttle brake linkage is easy, just get an ofna kit.
 
beason beasoln beason you know that hurts when you talk about my mt like that yes its true busted traded it back. what are you atlking about i kept it some what clean on ly dirty after a good run

neogeo202 here
 
I have the same motor ( .18cv) and i was woundering if you could give me a close up on how you did you throttle linkage. I have tried a few diffrent arrangements and my Throttle always seems to stick.
 
apoligies for the post on your screenname busted

wasent paying attention when i hit submit didnt realize i was under your name
 

RC Builds

Back
Top