• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Nitro Evader ST problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Mazzie

RC Newbie
Messages
1
Reaction score
0
Points
0
RC Driving Style
Hi all,
i recently was given an evader ST that didnt run. I got it running and stripped out the clutch bell in 4 tanks and to boot the fuel tank foams up and makes air in my fuel inlet line (i tried the rubber orings no difference) and stalls the engine under hard throttle. i replaced all fuel line sealed the engine to make sure there are no airleaks. inspected the fuel tank to find that the lid isnt sealing all the way. but there are no holes in the tank itself. i tried the rubberband over the lid and still have the same problem. anyone else out there have fueltank trouble with these trucks?
 
try tuning the high speed neeedle and it should help,and do u think u are reaching top speed if not lean it up.
 
Back
Top