I have a 2.5 t-maxx, so I purchased the wide a-arms, shafts and turnbuckles for a 3.3. the turnbuckles are to long for the stock steeringk knuckles. If I buy the knucklles for a 3.3, can I use the bearings from the 2.5 knuckles?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
need steering knuckles....
- Thread starter k5ranger
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I don't believe so. You will need the bearings as well since they are larger on the 3.3.
cwal1774
Hardcore RCTalk User
Check out ebay you can get a full set of knuckles on there for around 20 bucks with the bearings and pillowballs already installed.