my steering servo saver does not fit.

[pissant]

ok i bought a jr xs3 and iam using the torque metal gear servo for my steering and the saver that came with my savage does not fit on to it, what can i do, can i get a special made one for the jr sx3. thanks

-pissant

 

[mcvickj]

You will need a new servo saver. Most come with spline adapters for Airtronics, Futaba, Hitec, JR, and KO.

This is the one that I use.

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXS361&P=7

 

[1 Bad STi]

I 2nd, that Kimbrough saver, it works very well with either my hitec 615mg or my Jr z650

 

[Error401]

Unless HPI quit making and putting in spare parts, there should be the bottom end of the steering servo saver in the spare parts. The one that comes preinstalled is for HPI/Futaba servos. There should be two others on a spur, one for JR and one for Hi-Tec or some such, but there are two others in there some where. Same goes for the throttle setup.

Again, RTFM.