cbaker65
RCTalk VIP
- Thread starter
- #41
we've all done it i think. lol
LOL....I guess ,if you put something together while scratching your head ,isn't right!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
we've all done it i think. lol
hahaLOL....I guess ,if you put something together while scratching your head ,isn't right!
lol i know i definitely have!we've all done it i think. lol
glad you got it figured outOk ,rotating the trans spur gear the same way that the engine would be turning ,the front diff is the one that
is turning backwards ,so ,I have to pull the front diff an turn the spool around!...
Did that once or twice with the tmaxx. Didn't notice until I was at the skate park and fired it up... and it would just sit there and burn the clutch. Pick it up and the wheels would spin. Put it down and nothing. Felt like a doofus both times I did it!
do it! really curious how those tires are gonna do! defintely keeping it low should be really planted.
I had that happen on an LRP28S3 and OS21RG after the o-ring in the HSN dried up/shrank. I'd drive and it would lean itself out within minutes. New o-rings and they were tip top again.I tried it on the street a little the other day ,it fell on its face ,until I figured out what was wrong.
The silicone came off ,an when I looked at the mix meter screw ,it had vibrated all the way in ,so
I screwed it back out to flush an it started to run better ,so I shut it down to seal it back up ,later
I will see if one of my 28 carbs will fit ,that is what I had to do on my Hyper 21 engine ,chuck those
composite crap carbs!....?
I had that happen on an LRP28S3 and OS21RG after the o-ring in the HSN dried up/shrank. I'd drive and it would lean itself out within minutes. New o-rings and they were tip top again.