Losi Tenacity TT Pro ESC problem

[nakiz09]

Hi all,
I just bought myself this rtr rc. During calibration process, the esc cannot detect the brake function . Neutral position ok (green led light flashes once), full throttle position ok(green led flashes twice), full brake position( no signal from esc, led should flashes 3 times). Currently the rc only function forward and left/right. There is no brake and reverse function. I have no problem programming the esc. But its the calibrating the esc is where i got problem. Please advise. Thanks.

 

[tntpoof]

check radio make sure no trim is on throttle. it might take a few try's . I had a esc back a few years took me 50+ try's finally it calibrated correctly,

 

[Greywolf74]

Hi all,
I just bought myself this rtr rc. During calibration process, the esc cannot detect the brake function . Neutral position ok (green led light flashes once), full throttle position ok(green led flashes twice), full brake position( no signal from esc, led should flashes 3 times). Currently the rc only function forward and left/right. There is no brake and reverse function. I have no problem programming the esc. But its the calibrating the esc is where i got problem. Please advise. Thanks.

What kit and electronics are we talking about here?

 

[nakiz09]

Hi, thank you for all responses. I still a beginner in rc stuff. It is Spektrum SR6100AT receiver and Spektrum DX2E radio system. I re-bind them and as a result I can calibrate the esc successfully. Now I have the brake and reverse function. All is good now.

 

[Greywolf74]

Ok, good deal