Loosening Slipper Clutch

[ShooterMan86]

Hey, Guys i have a T-Maxx 3.3 4908. About at week ago i had to replace the pads on the slipper clutch because the clutch keeps coming lose and the pads fly off while in use. I've replaced them twice and the clutch keeps coming lose. I've tighten the clutch to where it is suppose to be. The only thing that i can think of is that i might not be putting it back together correctly. Is there anyone that can help me out with this or know of any videos that can help me? Thanks

 

[2revo1maxx]

You probably just need a new nut for it. When it slips too much it gets hot and then your nyloc nut gets burned out.

 

[Metalhead Matt]

Removable locktite.

 

[2revo1maxx]

That would probably hold it just fine but one adjustment and the loctite isn't locked anymore.

 

[olds97_lss]

New nut and locktite gel. That stuff stays tacky for quite some time and does a decent job holding.

 

[ShooterMan86]

Thanks guys i already bought a new Slipper Clutch Rebuild kit off ebay for $3.00. Hopefuly it will solve the proublem.