This bad boy comes with the following upgrades: CNC Chassis, CNC Knuckles, CNC Uprights, Torsen Diffs (Front and Center - both are new), PCR Chassis braces (front and rear), PCR Front Hinge Pin Holder, PCR Front Top Plate, PCR Center Top Plate, PCR Rear Toe In Plate (2.5 Degrees) Pro Line Knuckles mounted on dish wheels, a Trinity 1200 MaH NiMH Rx pack, and all of the other Pro Kit parts. The exhaust is the RB Concepts 86 one piece pipe w/manifold. The WS7 II has only had 1 gallon of 20% Trinity Monster Horsepower through it, and has really tight compression. This motor flat out screams. It also comes with two Hitec HS-645MG servos. All you need is a radio and receiver - and this is ready to race. This buggy is well taken care of, and has never been raced. I am only selling this brute because I just built a new Mugen MBX5, and no longer need this as a backup. I am looking for at least $700 for this monster.
Last edited:
